ידיות מחוממות לכידון האופנוע. פשוט להתקנה. מצבר -> מתג הפעלה -> ידיות הכידון.

Motorcycle  Heat Hand Grip Kit Pads Flexible

Features:

heat shrink tubing : Black

(heater size): 95x80mm

Voltage:12V

With ON/OFF switch

Keep your hands warm in cold weather riding.
Fits for all 12V motorcycle, E-bike and other vehicles.
Easy to install and operate.
Just need to wire this in to a positive wire from your ignition.
With all necessary bits and pieces to install these under your current handgrips.
If the bike doesn't have a battery,just need to locate the DC regulator.

Installation instructions:
1.Place the heat plate on the right position 
2.Wrap the heat plate around to the handlebars evenly,especially at the junction with the heating plate.
3.Put on the jacket tube and adjust the position,using a hot-air gun blowing outer sleeve shrinkage uniformity.
4.Mount the switch in the rod of the rear view mirror.
5.Connect the power line.Line Red and Line Black are not divided into positive and negative,but must installed  in the line control by the ignition key.

Package Included:

2 x heated grip pads

1 x heat resistant tape

2 x heat resistant covers

Due to the difference between different monitors, the pictures may not reflect the actual color of the item.

Compare the detail sizes with yours, please allow 1-3cm error, due to manual measurement.

Please leaving a message before you give the bad feedback, if the products have some problems.

Thanks for your understandings.